Advertisement
[ 1 ] Saddle stapling position adjustment
(1)
Turn OFF the power of the equipment.
(2)
Remove 2 screws and take off the board access cover [1].
(3)
Set the SW1 on the Finisher control board as shown in the figures below.
Turn ON pin 1 and 4.
(4)
Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
(5)
Press [Button 1] on the touch panel 10 times and then press [Button 2] once. Then press [Button
1] once again, and [Button 2] once again. (Adjustment of LD and A3 paper starts.)
© 2012 OKI DATA CORPORATION All rights reserved
Fig.6-124
LED3
LED2
Button1
Button2
Fig.6-125
6 - 109
[ 1 ]
LED1
ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
6
Advertisement
