Advertisement
[F101] HDD unmounted
[F102] HDD start error
[F103] HDD transfer time-out
[F104] HDD data error
[F105] HDD other error
Classification
Other service call
Check Item
HDD
Replacement part
HDD
SYS board
[F106_0] ADI-HDD error: Illegal disk replacement detected (ADI-HDD Exchange to SATA-HDD)
Classification
Other service call
Check Item
Setting
HDD
© 2012 OKI DATA CORPORATION All rights reserved
HDD unmounted: Connection of HDD cannot be detected.
HDD start error: HDD cannot become "Ready" state.
HDD transfer time-out: Reading/writing cannot be performed in
the specified period of time.
HDD data error: Abnormality is detected in the data of HDD.
HDD other error
•
Connector and harness check
•
Check if the connector pins of the HDD are bent.
•
Perform the bad sector check (08-9072). If the check result
is OK, recover the data in the HDD. If the check result is
failed, replace the HDD.
ADI-HDD error: The ADI-HDD has been replaced illegally to
SATA-HDD (normal type).
Check if the HDD has been replaced with a SATA-HDD
(normal type).
(1) Start the equipment in the 4C mode: [4] + [C] +
[POWER]
(2) Check the type of the HDD shown on the top left of
the control panel display "Current HDD type".
2a. In case of "SATA-HDD" (normal type), replace it with
the original ADI-HDD or a new ADI-HDD.
Notes:
To replace with the original ADI-HDD, start the
equipment in the normal mode and then reinstall
master data (HD Data) only if any abnormality
occurs.
2b. In case of "ADI-HDD"
Check each item in the Measures field for the HDD
below.
If the error still occurs, reinstall the master data (HD
Data).
•
Connector check
•
Harness check
•
Perform the bad sector check (08-9072).
If the check result is OK, recover the data in the HDD. If
the check result fails, replace the HDD.
8 - 179
Contents
Measure
Remark
Error item
Measure
ES9160 MFP / ES9170 MFP
ERROR CODE AND TROUBLESHOOTING
8
Advertisement
