Advertisement
9.2.8
Precautions and Procedures when replacing SRAM board
Notes:
Do not replace the HDD and the SRAM board together.
Be careful not to damage the board when replacing the SRAM board.
A procedure for replacing the SRAM board is shown below.
[A] Backup SRAM
Notes:
If "[A] Backup SRAM" fails, proceed to "[B]Replace SRAM board".
(1)
Install the USB media in the equipment, and then turn the power ON while pressing [5] and [9]
buttons simultaneously.
(2)
Key in [1] to select "1. Backup SRAM Data to USB", and then press the [START] button.
(3)
Enter a password (max. 15 characters) to be set for the backup data.
ES9160 MFP / ES9170 MFP
REPLACEMANT OF HDD/PC BOARDS
START
[A]
[B]
[C]
[D]
[E]
[F]
ADI-HDD
SATA-HDD
[H]
[I]
[J]
[K]
[L]
[M]
[N]
[O]
END
Fig. 9-17
9 - 20
[G]
© 2012 OKI DATA CORPORATION All rights reserved
Advertisement
