Oki ES9160 Maintenance Manual page 190

4.9.2 Fuser roller unit / Pressure roller unit
(1) Take off the fuser unit
( P. 4-75 "4.9.1 Fuser unit").
(2) Remove 1 screw and take off the rear cover
[1].
(3) Disconnect 1 connector [2].
Notes:
• When installing the rear cover [1], make
sure that the harness is not caught.
• Install the rear cover [1] with the ground
leaf spring [3] outside of it as shown in the
right-hand figure.
(4) Remove 2 screws and take off the fuser
roller unit and the pressure roller unit.
Notes:
When installing, be sure to release the
pressure release lever.
ES9160 MFP / ES9170 MFP
DISASSEMBLY AND REPLACEMENT
[2]
Fig. 4-214
Pressure
release lever
Release
Pressure roller unit
Pressure release lever
Fig. 4-215
© 2012 OKI DATA CORPORATION All rights reserved
4 - 76
[1]
[3] [3]
Fuser roller unit
Release