Advertisement
6.16.3
B4-size recycled paper mode settings
Set this mode if the trailing edge of the paper gets caught by the exit section of the finisher while B4-
size recycled paper is used. This mode increases the paper exiting speed when the paper exits to the
movable tray in the sort mode, or to the stationary tray in the non-sort mode.
(1)
Turn OFF the power of the equipment.
(2)
Remove 1 screw and take off the board access cover.
(3)
Set the SW1 on the Finisher control board as shown in the figures below.
(4)
Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
(5)
Press [Button1] and [Button2] as described in the following table to set the B4-size recycled
paper mode. Press [Button1] and [Button2] on the control panel as below to set the B4-size
recycled paper mode.
Notes:
Be sure to press [Button1] and [Button2] the correct number of times.
Press [Button1] and [Button2] simultaneously to cancel the operation.
© 2012 OKI DATA CORPORATION All rights reserved
Access cover
Fig.6-104
ON
1
2
3
4
Fig.6-105
LED3
LED2
Button1
Button2
Fig.6-106
6 - 93
SW1
LED1
ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
6
Advertisement
