Advertisement
(3)
Remove 5 screws, disconnect 2 connectors,
and then take off the HDD.
(4)
Remove 4 screws and then remove 2
brackets and the ground wire from the HDD.
9.1.3
LGC board
(1)
Take off the rear cover
(
P. 4-3 "4.1.6 Rear cover").
(2)
Disconnect 16 connectors, remove 4 screws,
and then take off the LGC board [1].
Notes:
When replacing the LGC board, remove
IC29 from the old board and then install it on
the new one.
•
When installing EEPROM (IC29)[2], be sure
that its pins are attached in the correct
direction and not misaligned.
•
Do not touch the pins of EEPROM (IC29)[2]
with your bare hands. (Be careful of static
electricity.)
ES9160 MFP / ES9170 MFP
REPLACEMANT OF HDD/PC BOARDS
HDD
Bracket
Ground wire
© 2012 OKI DATA CORPORATION All rights reserved
9 - 2
Fig. 9-3
Bracket
Fig. 9-4
[1]
[2]
Fig. 9-5
Advertisement
