Advertisement
[C150] PFP upper drawer tray is abnormal
[C160] PFP lower drawer tray is abnormal
Classification
Paper feeding system related service
call
Proce
Check item
dure
1
Does the tray go up?
(Perform the output check
in the test mode: 03-278/
280)
2
Is the tray-up sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]OFF/[2]/[D], /[3]/[D])
3
LGC board
Parts to be replaced
PFP board
LGC board
Tray-up motor
Tray-up sensor
ES9160 MFP / ES9170 MFP
ERROR CODE AND TROUBLESHOOTING
PFP upper drawer tray is abnormal
PFP lower drawer tray is abnormal
Result
Yes
No
1. Check if the connector of the tray-up motor
is disconnected.
2. Check if any of the connectors CN241 and
CN244 on the PFP board is disconnected.
3. Check if the connector CN318on the LGC
board is disconnected.
4. Check if the connector pins are
disconnected and the harnesses are open
circuited.
5. Check if the conductor patterns on the PFP
board and LGC board are short circuited or
open circuited.
6. Replace the PFP board.
7. Replace the LGC board.
Yes
No
1. Check if the connector of the sensor is
disconnected.
2. Check if any of the connectors CN241,
CN247 and CN248 on the PFP board is
disconnected.
3. Check if the connector CN318 on the LGC
board is disconnected.
4. Check if the slit reaches the sensor.
5. Check if the connector pins are
disconnected and the harnesses are open
circuited.
6. Check if the conductor patterns on the PFP
board and LGC board are short circuited or
open circuited.
7. Replace the PFP board.
8. Replace the LGC board.
1. Check if the conductor pattern on the LGC
board is short circuited or open circuited.
2. Replace the LGC board.
8 - 120
Error content
Measure
Remark
© 2012 OKI DATA CORPORATION All rights reserved
Next
Step
2
3
Advertisement
