Advertisement
Check item
Paper
Transport roller
Feeding sensor (S22)
Junction box paper detection sensor
(S26)
Transport path-2 (S27)
Transport path-3 (S28)
Ejecting roller sensor(S29)
Transport path switching solenoid
(SOL5)
Entrance motor (M1)
Transport path switching solenoid
(SOL9)
Interface PC board (I/F)
Saddle stitcher controller board
Replace parts
Junction box paper detection sensor
(S26)
Feeding sensor (S22)
Transport path-2 (S27)
Transport path-3 (S28)
Ejecting roller (S29)
Entrance motor (M1)
Transport path switching solenoid
(SOL9)
Interface PC board (I/F)
Saddle stitcher controller board
Finisher controller board
ES9160 MFP / ES9170 MFP
ERROR CODE AND TROUBLESHOOTING
Do not use the paper longer than the specification.
Fix any mechanical problem occurring when the transfer
roller is rotated.
•
Sensor check(S22)
•
Connector check
•
Harness check
•
Sensor check(S26)
•
Connector check(CN8)
•
Harness check
•
Sensor check(S27)
•
Connector check(CN20)
•
Harness check
•
Sensor check(S28)
•
Connector check(CN20)
•
Harness check
•
Sensor check(S29)
•
Connector check(CN20)
•
Harness check
Check that the gap between the transfer guide surface and
the upper surface of the flapper tip is in the acceptable range
according to the status of the transport path switching
solenoid (SOL5) (solenoid OFF: 1.5 to 2.1 mm, solenoid ON:
2.3 to 2.9 mm). If it is not, adjust it.
•
Motor check(M1)
•
Connector check(CN26)
•
Harness check
•
Solenoid check(SOL9)
•
Connector check(CN26)
•
Harness check
•
Board check
•
Connector check(CN1, CN2, CN5, CN7, CN8)
•
Harness check
•
Board check
•
Connector check(CN10, CN13, CN20)
•
Harness check
8 - 102
Measures
Remarks
© 2012 OKI DATA CORPORATION All rights reserved
Advertisement
