Advertisement
[D] State transition diagram of self-diagnosis modes
*1. Turn OFF the power after using the self-diagnosis modes, and leave the equipment to the user.
*2. Mode shown in the table "[C] List of modes"
[E] About each mode
•
Control panel check mode (01)
Operation procedure
[0][1]
LED lit/
[POWER]
LCD blinking
Notes:
•
The mode can be canceled by [POWER] OFF/ON when the LED is lit and the LCD is blinking.
•
Button Check
Press the buttons with LED to turn OFF the LED.
Press the buttons without LED to display the message on the control panel.
Press the button on touch panel to display the screen on the control panel at power-ON.
Press [execution] on the touch panel and then the [CLEAR] button on the control panel.
The screen then returns to the Button Check menu.
•
Test mode (03)
Refer to the following.
P. 5-8 "5.3 Input Check (Test Mode 03)"
P. 5-9 "5.4 Output Check (Test Mode 03)"
•
Test print mode (04)
Refer to the following.
P. 5-10 "5.5 Test Print Mode (Test Mode 04)"
•
Adjustment mode (05)
Refer to the following.
P. 5-11 "5.6 Operation Procedure in Adjustment Mode (05)"
© 2012 OKI DATA CORPORATION All rights reserved
[POWER]
Normal
ON
Authentication
Warming up
screen
Ready
Each mode
[POWER]
OFF
*1
To user
Fig.5-1
[START]
(Button check)
[START]
5 - 3
Self-diagnosis
mode
*2
[POWER] OFF/ON
(Exit)
ES9160 MFP / ES9170 MFP
SELF-DIAGNOSIS MODES
5
Advertisement
