Advertisement
11.5.4
Finisher firmware (MJ-1033)
(1)
Install the ROM [2] to the download jig (K-PWA-DLM-320) [1].
Make sure that the type of the ROM and the installation direction are correct.
(2)
Turn OFF the power of the connected equipment, and then release the Finisher from the
equipment.
(3)
Take off the rear cover of the Finisher.
(Refer to "MJ-1033/6008 Service Manual P4-4 [E] Rear cover")
* After taking off the rear cover of the Finisher, be sure to connect the finisher interface cable to
the equipment.
(4)
Connect the download jig [1] to the jig connector (CN5) [6] on the finisher control PC board (FIN).
(5)
Turn the power ON with the main power switch while pressing the digital keys [0] and [8]
simultaneously.
Updating starts and the LED on the download jig lights.
© 2012 OKI DATA CORPORATION All rights reserved
[6]
[1]
Fig.11-40
11 - 45
ES9160 MFP / ES9170 MFP
FIRMWARE UPDATING
11
Advertisement
