Oki ES9160 Maintenance Manual page 399

6.16.2 Adjusting the stapling position
Perform this adjustment after replacing the Finisher control board or when the stapling position must be
changed for some reason.
(1) Turn OFF the power of the equipment.
(2) Remove 1 screw and take off the board access cover.
(3) Set the SW1 on the Finisher control board as shown in the figures below.
When adjusting the trailing
edge side for A4 size paper
When adjusting the leading
edge side for A4 size paper
(4) Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
The alignment plate moves to the rear or front side stapling position and stops. (It stops at the
position of -20 steps from the center value of the adjustment range.)
© 2012 OKI DATA CORPORATION All rights reserved
Access cover
Fig.6-101
When adjusting the trailing
edge side for LT size paper
ON
1 2 3 4
When adjusting the leading
edge side for LT size paper
ON
1 2 3 4
Fig.6-102
6 - 91
SW1
ON
1 2 3 4
ON
1 2 3 4
ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
6