Oki ES9160 Maintenance Manual page 192

4.9.4 Fuser roller
(1) Take off the separation fingers
( P. 4-77 "4.9.3 Separation finger").
(2) Remove 6 screws and take off the fuser
roller and three heater lamps.
Notes:
1. Be careful not to deform the fuser roller
by pushing strongly.
2. When installing the heater lamps, refer to
the installation procedure.
( P. 4-79 "4.9.5 Heater lamp")
3. When installing the fuser roller, be careful
not to deform the thermistor.
4. When installing the fuser roller, confirm
that the drive gears are engaged.
(3) Remove 1 C-ring and 1 bearing from the
fuser roller front side.
(4) Remove 1 C-ring, 1 gear and 1 bearing from
the fuser roller rear side.
ES9160 MFP / ES9170 MFP
DISASSEMBLY AND REPLACEMENT
Fuser roller
Fig. 4-219
C-ring
Bearing
Fig. 4-220
© 2012 OKI DATA CORPORATION All rights reserved
4 - 78
White(M4)
Blue
Center
Sub
Side White(M3)
Bearing
Gear
C-ring