Advertisement
(3)
Remove 1 screw and take off the recovered
toner drive unit. Remove 1 gear.
(4)
Remove 2 plate springs fixing the doctor
sleeve on its both ends.
(5)
Remove 2 screws on both ends of the doctor
sleeve and remove 2 coil springs.
Notes:
When the screws on both ends of the doctor
sleeve are removed, be sure to adjust the
doctor sleeve gap (0.45±0.05 mm) after
assembling.
(6)
Remove 1 screw and plate spring.
(7)
Remove 1 screw and take off the polarity
adjustment lever.
Notes:
Make a note of the position where the
polarity adjustment lever is pointing. (Mark
the position if needed.) When reassembling,
match the polarity adjustment lever with the
previously marked position on the scale.
© 2012 OKI DATA CORPORATION All rights reserved
Recovered toner drive unit
Fig. 4-189
Plate spring
Fig. 4-190
Coil spring
Fig. 4-191
Polarity adjustment lever
Fig. 4-192
4 - 69
Gear
Plate spring
Screw
Plate spring
ES9160 MFP / ES9170 MFP
DISASSEMBLY AND REPLACEMENT
4
Advertisement
