Advertisement
[EA32] Exit paper remaining jam
Classification
Paper jam in finisher section
MJ-1101
Check item
Processing tray sensor
Finisher controller PC board
Parts to be replaced
Processing tray sensor
Finisher controller PC board
MJ-1106
Check item
Finisher
Processing tray sensor (S12)
Finisher control PC board
(FIN)
Parts to be replaced
Processing tray sensor (S12)
Finisher control PC board
(FIN)
[EA32] Finishing tray paper detection error
Classification
Paper jam in finisher section
MJ-1032
Probable cause
Finishing tray sensor (S4)
abnormality
Faulty cables and connectors
Finisher control PC board (FIN)
abnormality
© 2012 OKI DATA CORPORATION All rights reserved
Error content
Exit paper remaining jam
Measures
•
Sensor check (S12)
•
Connector check (CN11)
•
Harness check
•
Sensor check
•
Connector check (CN11)
•
Harness check
Remark
Measures
Check if there is any paper in the finisher or on the transport path of
the equipment and remove it if there is.
•
Sensor check
•
Connector check
•
Harness check
•
Board check
•
Connector check (CN18)
•
Harness check
Remark
Error content
Exit paper remaining jam
Checking and measures
Measure the voltage on TP14 on the finisher control PC board (FIN).
Then check that the measured voltage is 1V or lower when not
shielded and within the range of 3.3V
does not fall within the range mentioned, replace the sensor.
Check if the electrical continuity between the connector terminals is
normal. If electricity is not conducted, replace the connector. (Finisher
control PC board (FIN): CN5)
If the error still occurs after replacing the sensor and the
connector, exchange the finisher control PC board (FIN).
8 - 95
±
5% when shielded. If the voltage
ES9160 MFP / ES9170 MFP
ERROR CODE AND TROUBLESHOOTING
8
Advertisement
