Epsr Mode Master Controlvlan Primary Port - Allied Telesis x510-28GTX Command Reference Manual

E P S
THERNET ROTECTION WITCHED

EPSR MODE MASTER CONTROLVLAN PRIMARY PORT

epsr mode master controlvlan primary port
Overview This command creates a master EPSR instance.
NOTE
Syntax epsr <epsr-instance> mode master controlvlan <2-4094>
primaryport <port>
NOTE
The software allows you to configure more than two ports or static channel groups to
the control VLAN within a single switch or stacked node. However, we advise against
this because in certain situations it can produce unpredictable results.
Mode EPSR Configuration
To create a master EPSR instance called blue with vlan2 as the control VLAN and
Example
port1.0.1 as the primary port, use the command:
awplus(config-epsr)#
primaryport port1.0.1
Related epsr mode transit controlvlan
Commands
show epsr
C613-50170-01 Rev B
R (EPSR ™) C
ING ING OMMANDS
: Running your switch as an EPSR master node requires a feature license.
Parameter
<epsr-instance>
mode
master
controlvlan
<2-4094>
primaryport
<port>
:
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Name of the EPSR instance.
Determines the node is acting as a master.
Sets switch to be the master node for the named EPSR ring.
The VLAN that will transmit EPSR control frames.
VLAN id.
Primary port for the EPSR instance.
The primary port. The port may be a switch port (e.g.
port1.0.4) or a static channel group (e.g. sa2). It cannot
be a dynamic (LACP) channel group.
epsr blue mode master controlvlan vlan2
2156