Mode 7-Synchronous Burst Read Operation Mode - Texas Instruments OMAP5912 Reference Manual

Multimedia processor device overview and architecture

Hide thumbs Also See for OMAP5912:

Table of Contents

Mode 4 Synchronous Burst 4x16-Bit Read Operation on Multiplexed

Address/Data 16-Bit Width Device With Retiming on (RDWST=3, FCLKDIV =0,

ADVHOLD=0, OESETUP = 3, RMODE=4). Data write-back on the bus after read

FLASH.A/D(15:0)/

FLASH.A(25:16)

Retimed data(15:0)

FLASH.BE(1:0)

Mode 7—Synchronous Burst Read Operation Mode

Valid address

The synchronous burst read mode 7 is selected by setting the RDMODE

bit field in the corresponding EMIFS chip-select configuration register

This mode only supports synchronous read accesses (single or

consecutive). This protocol is used when accessing boot ROM and secure

The following diagrams show 16−bit external device widths. Similar accesses

occur when using the 32−bit width of the secure RAM and boot ROM.

Î Î Î Î Î Î Î

OMAP3.2 Subsystem

Traffic Controller

Chapters

Table of Contents