Mitel SX-200 Documentation page 87

ATTENDANT DATE DISPLAY
Description
The Attendant Console will display rhe date if the appropriate console
button is depressed. Month and date are initially shown, followed a
short time laler by the year. The date may be set by dialing the
relevant code; is not necessary to enter the programming mode.
it
Conditions
Feature Number 18 (Attendant Function) must be assigned an access
code. For the purposes of the foliowing description this will be as-
sumed to be x
In the event of a power failure, the date is not lost. However, if the
power failure extends over midnight it will be necessary to reset the
date, since it is incremented by the transition of the clock from PM to
AM (or 23.59 to 00.00). During a power failure the clock does not
function.
Date and time may not be displayed simultaneously.
l
Some tr&Fic measurements may be lost with a date change.
l
Programming
None
Operation
To set the date:
Dial x15.
l
Dial in a 2-digit code for the month.
l
Dial in a 2-digit code for the date.
l
Dial in a Z-digit code for the year.
l
Press the RELEASE button - the date is now set.
l
To see the date:
Press the IDENT button - the month and date are displayed in
l
place of the time.
Hold down the IDENT button - after a 5 second delay, the month
l
and date are replaced by the year.
Release the IDENT button - the time is again displayed.
l
SECTION MITL9105/9'llO-096-l OS-NA
Page 33