Mitel SX-200 Documentation page 405

SECTION MITL9105/9110-096-150-NA
Page 2
SX-100 Free-standing
2.06 The SX-100 equipment cabinet (Figure 2-2) is of welded steel
construction and measures 422 mm (16.62 in.) high, 635 mm (25
in.) wide and 470 mm (18.5 in.) deep. A fully equipped cabinet weighs
approximately 31.8 kg (70 lb). The door on the front of the cabinet
provides access to the system maintenance panel, printed circuit cards
and primary power supply controls. Access to the line and trunk con-
nectors and the power supply cable harness is provided by removing
the rear panel. Cable entry to the equipment cabinet is provided
through cable duct at the rear of the cabinet.
SX-200 Equipment Cabinet
2.07 The SX-200 equipment cabinet (Figure 2-3) is of welded steel
construction and measures 960 mm (38 in.) high, 600 mm (23.5
in.) wide and 700 mm (27.5 in.) deep. A fully equipped cabinet weighs
approximately 131.7 kg (290 lb). The door on the front of the cabinet
provides access to the system maintenance panel, printed circuit cards
and reserve battery supply shelf. The hinged rear panels hold the
system power supply and provide access to the line and trunk connec-
tors and the reserve power controls. Cable entry to the equipment
cabinet is provided through cable ducts on either side of the cabinet.
2.08 The equipment cabinet holds the maintenance' panel, a maxi-
mum of two equipment shelves (see Figure 2-4), the optional
reserve battery supply and the primary power supply. The maintenance
Figure 2-l System
or Wall-mounting Equipment
TRUNK
Configuration
Cabinet