Mitel SX-200 Documentation page 686

i b ,i f
:$;:
!$!
' l ? i
SECTION MITL91 OS/91 1 O-096-451-NA
\. .I
3. INSTALLATION
General
3.01
Installation, to meet the Station Message Detail Recording re-
quirements, consists of the following steps:
(a) Verification that Generic 217 software is included in the SX-100
or SX-200 PABX system.
(b) Determination of the required output configuration (Figures 3-l
and 3-2).
(c) Installing the hardware items.
(d) Programming and operation of the completed system (Parts 4
and 5).
. .
Printer Configuration
3.02 The SX-100 and SX-200 PABXs have an RS-232 data port to
the SMDR facility. A local printer may be connected to this port
to provide an on-premises printout (Figure 3-l). The port may also be
connected to a remotely located facility via an RS-232 adapter and a
modem (Figure 3-2). The required printer characteristics are as fol-
lows:
(a) 80-character line length. If the system identifier is to be printed
(System Option 283 enabled), an 88-character line length is
required.
(b) 300- or 1200-baud character rate. Baud rate ~ is switch-
selectable on the PABX scanner card to accommodate the rate.
(c) The subset of required ASCII characters is illustrated in Table
3-1.
(d) Each line printout from the PABX data port is terminated by a
"carriage return" and "line feed" character. For printers which
required an extra delay, six "NULL"' characters may be added to
the termination (System Option 313). For a further additional
delay, select System Option 314 (Printer Transmit Additional
Nulls).
Page 9
_i