Mitel SX-200 Documentation page 692

SECTION MITL91 OW911 o-096-451 -NA
.:
! ., .-
i
: .
TABLE 4-2
SMDR CONSOLE FUNCTION CODES
System
Options
Description
Part A - Attendant Function Codest
*14* Suspend Printout. SMDR output may be suspended by the console
attendant; for example, in order to change paper. The command is as
follows:
Enter '14" from keypad
Press RELEASE button.
Printout is suspended at the end of a current line if one is being printed.
No output is lost. Caution should be observed in using this function code
because if it is set for an extended period it may result in the build-up of
busy conditions on outgoing trunk groups and the prevention of incoming
trunk calls.
*14#
Resume Printout. Traffic data output may be resumed after either a
"suspend" or "ignore" (see below) by the console attendant as follows:
Enter *14# from keypad
Press RELEASE button.
'1400 Purge and Ignore Printout. SMDR output may be ignored (inhibited) by the
console operator if the required arises to use the printer for other
purposes. The command is as follows:
Enter "1400 from keypad
Press RELEASE button.
All printout is ignored and lost. System Option 311 (see Table 4-l) must
be enabled for this command to be effective.
Part B - Maintenance Function Codes
(It is assumed that 555 is the maintenance function code in the list)
Some of the console function codes must be duplicated from the PABX
test line and perform the same function. These are listed below:
555 + 8 + * or 1 Suspends printout. The last symbol may be replaced by 1 on the rotary
dial.
555 + 8 + # or 2
Resumes printout. The last symbol may be replaced by 2 on the rotary
dial.
555 + 8 + 00 Ignores printout. System Option 311 (see Table 4-l) must be enabled for
this function to be effective.
T This document assumes that the * symbol has been assigned as an access code to feature
number 18 (Attendant Function).
Page 15