Mitel SX-200 Documentation page 461

SECTION 9105/911
. .
7. PROGRAMMING AND NUMBERING
A. General
B. Programs
Page 22
Installation Requirements
6.06 The installation
tion.
Cabling and Cross-Connections
6.07 The following paragraphs detail the cabling and cross-
connections required when installing the electronic PBX.
Telephone Set and Trunk Cabling
6.08 Telephone set and trunk cabling terminates on the building
cross-connect terminal in the normal manner. The cabling re-
quirements and limits for stations and consoles are shown in Figures
6-l and 6-2, Section MITLS 105/9 11 O-096-200-NA.
Cable Terminals
6.09 Section MlTL9105/91
Installation, gives full details of the requirements for inter-
connection of cables between the building cross-connect terminal and
the connector locations in the rear of the cabinet (see Figures 6-3 and
6-4, Section MITL9105/91 lo-096-200-NA). This includes the power fail
transfer connections between the cabinet and the cross-connect ter-
minal.
The firmware of the SX-lOO/SX-200 system is written in a
7.01
manner that allows maximum flexibility during installation or
whenever a change is required. The features discussed in Part 5 of this
Practice are built into the system and may be.enabled or disabled with
a simple change of parameters by the installer or repairman. This
procedure is called programming and may be accomplished from ei-
ther a Maintenance Console or an Attendant Console. Full details of the
programming procedures are contained in Section MlTL9105/91
7.02 Seven service programs, in the following order, are initially
placed in the system to control the entry of subsequent data:
System Options
Class-of-Service
l
Access Code Assignments
l
Extensions
l
Extension Hunt Groups
Trunks
l
Trunk Groups.
l
requirements
a r e
Shipping, Receiving and Installa-
Shipping, Receiving and
Options
d e t a i l e d i n S e c t i o n