Mitel SX-200 Documentation page 517

SECTION MITL91 OS/91 1 O-096-21 Z-NA
Error
E O All Modes
El Trunk Group Mode
Control Plan Mode
E2
All Modes
E3 Control Plan Mode
E4 Table Mode
E5 Table Mode
E7
Page 22
TABLE
PROGRAMMING
Applies to:
Mode
Mode
8-2
ERRORS
Meaning
invalid button pressed. Consult MAP for correct
procedure. System Option 292 may not be
enabled.
Number is not within the range of the
parameter being defined. Re-enter parameter
button defined.
An attempt was made to leave the current mode
after some parameters were changed but before
ENTER or CANCEL was pressed. ENTER may be
used to write the new programming information
back to the non-volatile RAM, or use CANCEL to
ignore all programming changes made since the
last time ENTER was pressed.
The number entered is not valid. Re-enter a
number which exists.
The table entry code is invalid for the table
programmed. This occurs in the following
situation:
1. A code of more than three digits in length for
an 800-entry or 20-range table.
2. A code not in the range of 200-999 for an
800-entry table.
3. A code which already exists, or a code which
would be ambiguous in conjunction with the
existing table entries, for a 4-entry table.
The table is full and cannot hold the entry.
Control card switches are not 7776 or the system
is not idle.
A hardware failure was detected while clearing
the extended customer non-volatile RAM.