Mitel SX-200 Documentation page 159

Operation
Dump:
1 . If a tape is used, ensure that it is of the correct length as
outlined in the Conditions part of the page, and start the tape at
the beginning.
2. Disconnect the device currently connected to the system RS-
232 port and connect the recording device to the RS-232 port.
Place the recording device in the recording mode.
3. Dial 555 + 71% for an entire dump or dial 555 + 71 and the data
block from Table 2-6.
Dial the appropriate data block number (from Table 2-6), with
each block separated by an JC and another x to signify the end
of the entry, or dial x to dump all the RAM data.
4. Dial ~141%
Press the ENTER button on the console to start the -dump. The
5.
scanner card display will show AA and all LEDs on the IPC will
be lit. For the duration of the dump, LED 3 on the IPC will be
glowing.
. .
6. When the dump is over, as indicated by LED 3 on the IPC
extinguishing, restart the port by dialing %14# from the console
and pressing the ENTER button.
Block
N u m b e r
1
3
4
5
6
7
8
To Load Data Block 1:
1 . When loading the system, Data Block 1 (Table 2-6) must be
present or be loaded first.
2. To load Data Block 1, set the thumbwheel switches on the Tone
Control card to 4648.
3. Disconnect the device currently connected to the RS-232 port.
SECTION MITL91 OS/91
TABLE 2-6
CUSTOMER DATA BLOCKS
Customer
Information
All Standard Programming and the SUPERSET
Customer Data
ARS
Multi-Digit Toll Control
Station Information (extension meters, room
status, etc.)
Alarm Call
System Speed Call
Data Block
10-096-l OS-NA
Page 105