Mitel SX-200 Documentation page 23

3. ATT. Indicates that the attendant is talking to the called party.
RING. Indicates that the called party is ringing.
4.
5 . BUSY. Indicates that the called party is busy.
6. ERR. Indicates to the attendant that an invalid number has
been dialed.
Console Faceplate
The console faceplate holds the following buttons:
LAMP TEST. This button, when pressed, causes all the console
or displays can be readily detected. In addition, the display will
lock if the LAMP TEST button is depressed longer than 5 s, and
release when any button is pressed or any action requiring the
attendant occurs.
ALARM RESET. This button is pressed to reset the audible
alarm signal in the event of an alarm, and also displays an
alarm identification code in the Source and Destination display
areas.
BELL OFF. The console bell is disabled when this button is
pressed. The LED associated with
off condition. The bell can be reactivated by pressing the button
again.
operation of this button will display the circuits used in the
connection. The circuits
button is held down. When the console is idle, pressing the
console identification. In either situation, the date will appear in
the TIME display.
NIGHT 1. This button is used to switch the PABX into and out
of Night Service 1. The associated LED, when lit, indicates that
the PABX is in Night Service 1.
NIGHT 2. This button is used to switch the PABX into and out
of Night Service 2. The associated LED, when lit, indicates that
Night Service 2 has been selected. Night Service 1 and Night
Service 2 are mutually independent of each other.
ROOM RESTR. The ROOM RESTR button is used to prevent
unauthorized outgoing calls from guest rooms when they are
vacant.
ROOM STATUS. The function of this button is to monitor the
status of each room. Pressing this button and dialing one of
five possible single digit codes indicates, on the BUSY LAMP
SECTION MiTL91 OS/91
the
button indicates the bell
used
are displayed for as long as the
10-096-l 00-NA
--
Page 17