Mitel SX-200 Documentation page 693

SECTION MITW105/911 o-096-451 -NA
4. PROGRAMMING
!
General
4.01 This Part describes the programming options and procedures
which 'are required in connection with Station Message Detail
Recording and also refers to other options which are of particular
interest to SMDR.
4.02 System and COS Options which are directly applicable to SMDR,
and other options which are required for printer operation, are
described in Table 4-1.
4.03 Console Access Function codes which are required to perform
printer control functions from either an attendant or a
maintenance console are listed in Table 4-2.
4.04 Account Code programming options and features are described
in Appendix A
Programming Procedures
4.05 Programming procedures for the SX-100 and SX-200 PBXs are
detailed in Section MITL9105/9110-096-210-NA. When the
SMDR facility is a requirement, the SMDR options and features should
be programmed with the other options and features for new
installations, or they may be added for existing installations.
4.06 The SMDR facility is not effective unless the proper Trunk
Group type is programmed. Thus, SMDR reporting can be
restricted to only certain Trunk Groups. When so programmed only
this type will force an account code (Appendix A) to be entered before
dialing the trunk group. When entering the Trunk Group program, as
detailed in Section MlTL9105/91 lo-096-210-NA, the I-digit type must
have, as the second digit entered, the digit "3" or "4". When the digit
"4" is entered, the Message Registration feature also applies to this
Trunk Group.
4.07 On completion of programming, the SMDR facility will be
operational. A brief outline of the operational procedures with
examples of SMDR printouts is contained in Part 5.
5. OPERATlONAL PARAMETERS
General
5.01 There are no special operational procedures employed by the
attendant or extension, except when account codes are
required to be reported. In this case, the procedures outlined in f'
Appendix A are followed. The following operational parameters should
be noted when SMDR is used,