Mitel SX-200 Documentation page 462

Superswitch electronic private automatic branch exchange epabx
Hide thumbs Also See for SX-200:
Table of Contents

Advertisement

7.03
Other additional service programs, depending upon the type of
software installed in the PBX, may be implemented. These are
listed below and include relevant MITEL
should be consulted for descriptions and programming requirements.
(a)
Traffic Measurement: see Section MITL9105/91 lo-096-450~NA.
(b) Multi-Digit Toll Control:
(c)
Station Message Detail Recording: see Section MITL9105/91 lo-
096-45 1 -NA.
(d)
Speed Call: see Section MITL9105/91 lo-096-220-NA.
(e) Automatic Route Selection: see Section MITL9105/9110-096-
7.04
The scope of the programming capability caters to all changes
which may be expected during the normal operation of the PBX;
i.e., no modification or wiring and component changes are necessary.
The foregoing programs are discussed in more detail in the following
paragraphs.
System
Options
7.05
System Options are those that affect the overall system includ-
ing those relating to the console operation. A typical example is
given below:
Discriminating Ringing. A call originating external to the sys-
tem results in a double ring signal, whereas an internal call
results in a single ring signal. If this option is enabled it affects
ALL extensions within the system.
Classes of Service
7.06 Classes of Service are sets of features and/or restrictions
which can be applied to a single extension or to a group of
extensions. These classes are then subsequently assigned to exten-
sions in the Extension program or to trunks in the Trunk program.
Examples of Class-of-Service Options are:
Paging Access. An extension which has Paging Access in its
Class of Service can dial the appropriate code(s) and be con-
nected to a user-supplied paging system(s).
Executive Busy Override. An extension with Executive Busy
Override in its Class of Service can "barge-in" to a conversation
by dialing a code over the busy tone.
Station Override Security. It is also possible to set the Station
l
Override Security option which will disallow another extension's
override capability.
SECTION 91 05/911 O-096-1 80-NA
Practice references, which
see Section MITL9105/9110-096-
Page 23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sx-100

Table of Contents