Mitel SX-200 Documentation page 637

SECTION MITL91 OW911 o-096-31 5-NA
7.31 TRUNK GROUP:
Pressing this button, after the route number
has been dialed, and then dialing the Trunk Group number
allows this Trunk Group to be assigned the dialed route number.
7.32
MODIFY
DIGITS:
This button is used in conjunction with the
DIGITS DELETE and DIGITS ADD buttons to create the proper
routing digits for particular route number, irrespective of those in-
serted by the user.
7.33 DIGITS DELETE:
This button is pressed to enable digits to be
canceled from the user's dialed routing digits. This is affected
by pressing the button and dialing the numbers of digits to be deleted.
7.34 DIGITS ADD:
In a manner similar to that for the DIGITS DELETE
button, routing digits are added to the customer's dialed num-
. ber. In this case however, after the button is pressed, the actual (not
quantity) routing digits required are dialed.
7.35 LOCAL AREA: Pressing this button, and dialing the Local (Home)
Area Code allows interchangeable office codes (i.e., NXX Office
Codes) within the customer's area to be recognized.
Buttons
- SUPERSET
Extended Programming Mode
I .
7.36 When programming a SUPERSET set, a console overlay different
to the Standard and Extended overlays must be used. This '
overlay is shown in Figure 6-2(F); the system must be in the Extended
c
Programming when using the overlay. For further information on the
SUPERSET 3 set, see Section MITL9105/911 O-096-106-NA or for the
SUPERSET 4 set, see Section MITLS 105/911 O-096- 107-NA.
7.37 LAMP-TEST:
The LED associated with the LAMP TEST button
will be lit steadily when the system is in the standard program-
ming mode, and will flash when the system is in the extended pro-
gramming mode. Pressing th,e LAMP TEST button while the switches
on the Scanner card are set to 777X (where X is the console number
O-Z) will put the system in the standard programming mode.
7.38 SUPERSET:
The SUPERSET button selects the SUPERSET pro-
gramming mode when the system is in extended programming.
The SUPERSET button will be lit for the duration of the SUPERSET
programming.
7.39
CANCEL:
Pressing the CANCEL button after making a data entry,
will remove all new data from temporary storage, and allow
new (correct) data to be entered.
7.40 SET EQPT NUMBER:
Pressing. this button allows the selection
of the equipment number to be programmed as a SUPERSET
equipment number.
,-.l
7.41 PRIME KEY:
The PRIME KEY button selects the prime line of the ,,.:
SUPERSET set for programming. The prime key is always button
@
"
number 1 on the SUPERSET 4 set. Every SUPERSET 4 set must have
Page 36