Mitel SX-200 Documentation page 509

SECTION MITL91 OS/91 1 O-096-21%NA
CONTROL PLAN #l
1. DENY NO EXCEPTIONS
2. ALLOW
3. DENY
4. ALLOW NO
5. DENY EXCEPTIONS
Figure 5-5 Control Plan 1 of Example
. .
Page 14
2122
5.13 The extension programming must be performed to define the
paths to be taken within the Trunk Groups. Group A users will
be completely allowed in all Trunk Groups, so their extensions need
only be programmed with 'TOLL DENY - DELETE".. Group B users are
only completely allowed when accessing one Trunk Group (#3), so the
same thing cannot be done with this group of users. Here, we will
program their extensions with "TOLL DENY l", meaning Class of Re-
striction 1 will be taken in the Trunk Groups they are accessing.
Similarly, Group C users' extensions can be programmed with "TOLL
DENY 2" which will define the path
Trunk Group.
CONTROL PLAN #3
BASIC CONDITIONS:
1. A L L O W NO EXCEPTIONS
2. A L L O W
NO
3. A L L O W EXCEPTIONS
4. A L L O W
5. A L L O W
Figure 5-7 Control Plan 3 of Example
CONTROL PLAN #2
BASIC CONDITIONS:
1. DENV
2. DENY
DENV
3.
4. A L L O W
5. DENV
N O T E : APPLV AN 800-ENTRV EXCEPTION TABLE WHERE IT WOULD
ENABLE CO CODES (IN THE HOME AREA CODE) TO BE DENIED.
THIS MAV BE DESIRABLE IF SOME CO CODES ARE OUTSIDE
THE 'PRIMARY' CALLING AREA.
Figure 5-6 Control Plan 2 of Example
taken
when Group C users access a
9
NO EXCEPTIONS
N O
N O
EXCEPTIONS (SEE NOTE)