Mitel SX-200 Documentation page 663

SECTION MlTL9105/91 lo-096-450-NA
i:,
..'ji
4. OUTPUT CONFIGURATION
!V
'.\
General
4.01 Figure 4-l shows the external connections to the PABX data
port connector J302. The port may be connected via an RS-232
Adapter, either to an external modem for the remote polling facility or
to a local terminal (printer). Both types of connections cannot be
simultaneously employed.
Output Control
4.02 Traffic output may be controlled in one of three ways:
0
By polling from an external device
l
By specifying that the data be printed automatically every hour
(Autoprint)
l
By requesting output from the console via an attendant func-
tion.
External Polling Mode
4.03 The polling mode of operation allows an external device to poll ,'
the PABX and request that traffic data be output to it. The (i
device sends control characters to the PABX via the RS-232 port to
enable or suspend the output. Other types of printouts (e.g., Message
Registration Printing) cannot be obtained in the polling mode.
Autoprint Mode
4.04 As an alternative to the Polling mode, the hourly printout may
be output automatically (Autoprint). The Polling mode and
Autoprint mode cannot be simultaneously enabled (see Figure 3-l and
Table 6-2).
Console-Controlled Outputs
4.05 Traffic measurement data may be printed on request from the
console if the Polling mode is not selected. Part 6 details the
required operation. This data may be obtained at any time except
under the following conditions:
(a) Printouts cannot be requested if the Polling mode has been
selected.
(b) If Autoprint mode has been enabled and the PABX is 'in the
process of printing a Traffic Report at the time a Hotel/Motel
printout is requested, the latter printout will not occur until
completion of the Autoprint printout.
Page 20
I