Mitel SX-200 Documentation page 691

SECTION MITL9105/911 O-096-451-NA
System
Options
118
314
277
278
279
280
281
282
283
284
311
313
171
TABLE 4-l
SMDR OPTIONS
SYSTEM OPTIONS
Description
Attendant Printer Control Enable. This Option must be selected to enable
the use of the printer commands "14 (Table 4-2).
Printer Transmit Additional Nulls. This Option should be enabled when
using the MITEL Printer at 1200 baud.
Station Message Detail Recording: Outgoing Calls. This Option enables the
Station Message Detail Recording feature for outgoing trunk calls.
Station Message Detail Recording: Incoming Calls. This Option enables the
Station Message Detail Recording feature for incoming trunk calls.
SMDR: Record Only Incoming CO Calls. If this Option is selected, incoming
calls on incoming CCSA, DID and Non-Dial tie trunks are not recorded.
The recording of incoming calls on Dial-in tie trunks and DISA trunks is
controlled via COS Option "No SMDR Record For This Line".
SMDR: Record Meter Pulses. If this option is selected, the number of
meter pulses generated by the Central Office is reported in the SMDR
record. With this Option, the number of digits recorded on the trunk is 20.
If it is not selected, the number of digits is 26. This Option is not
meaningful unless System Option 277 is also selected.
SMDR: Drop Incomplete Outgoing Calls. If this Option is selected,
outgoing calls that are incomplete are not reported. If a Trunk Group is
programmed for Answer Supervision, calls that do not receive Supervision
are not reported. If a group is not programmed for Supervision, a
"pseudo-answer supervision" time-out must be assumed. Calls that last
less than that time are not reported. The same timer is used as for
Message Registration; i.e., it
is
20, 30 or 40 seconds depending on the
status of Options 194 and 195.
SMDR: Drop Calls of Less Than Eight Digits. If this Option is selected,
outgoing calls in which less than eight digits are dialed on the trunk are
not reported. This Option is only meaningful if Option 277 is also enabled.
SMDR: Extended Record. If this Option
is
enabled, the length of the SMDR
record is extended from 80 to 88 columns. This allows the last four
columns of 12-digit account codes and the System ID to be reported.
SMDR: Indicate Long Calls. If this Option is selected, calls of 5 minutes or
longer are flagged in the SMDR record (see also Table 2-l).
Ignore Print Enable. This Option must be enabled if the Attendant Function
"1400 (Table 4-2) is Jo be effective.
Printer Carriage Return Delay. The Option causes six nulls to be sent to
the printer following Carriage Return/Line Feed. This delay is not required
by some printers. If this Option is not selected, no nulls are sent.
This Option enables digits dialed to be stored in memory and not
outpulsed until a trunk is seized.
Page 14