Mitel SX-200 Documentation page 158

SECTION MITL9105/911
CUSTOMER DATA DUMP/LOAD
Page 104
Description
This feature allows the contents of the Non-Volatile RAM (the cus-
tomer data) to be dumped on a storage device. Any RS-232 compatible
recording device may be used. This data may be used to reprogram a
system or program an alternate system (with the same customer data).
Conditions
The system can accommodate any of the following characteristics:
RS-232C interface.
l
ASCII characters variable selection (5-8 data bits, 1, 1.5 or 2 stop
l
bits).
Parity enable with choice of odd or even transmission.
l
l
System Options 373 (Printer Carriage Return Delay) and 314
l
(Printer Transmit Additional Nulls) should be disabled for any
d u m p .
System Option 151 (Data Demultiplex Enable) and System Option
l
300 (Traffic Measurement Polling) should be disabled for any
d u m p .
Dump:
If the RS-232 port is in use when a Dump is requested, the .
l
request will be ignored and busy tone returned.
The Dump function can be performed in 36 minutes at 300 baud
l
or 9 minutes at 1200 baud. If 7200 baud is required a MITEL PN
91 lo-104-OOO-NA
Load:
During a Data Load the system operates in the Power Failure
l
Transfer mode.
The load function takes 36 minutes at 300 baud, or 9 minutes at
l
1200 baud.
If the first data block is not in the correct format or if a check-
l
sum error is detected, the load is terminated.
Programming
Assign an access code to Feature Number 18 (Attendant Func-
l
tion), usually x as indicated under Operation.
If the system is to be remotely reset, select System Option 166
l
(Remote System Reset Protection Override).
Select System Option 118 (Attendant Printer Control Enable) to
l
control the printer from the console.
Select System Option 311 (Ignore Print Enable).
l
Assign an access code to Feature Number 19 (Maint. Function).
l
Scanner card is required.
. . .