Mitel SX-200 Documentation page 695

SECTION MITL91 OW911 o-096-451 -NA
Incoming
Calls
i
5.05
ia)
(b)
(c)
((4
When SMDR is enabled for incoming calls (System Option 278).
the following conditions are reported:
Digits dialed on incoming DID, DISA or Dial-in tie trunks are
reported in the "Digits Dialed on the Trunk" field. if the Dial-in
trunk dials an illegal or vacant number or hangs up before
completing the number, the call is still reported. The called
party is the extension dialed. The DISA Security Code is not
reported.
The called party is the attendant unless the attendant then dials
an extension. In that case, the called party becomes the
extension
and an rr*" is reported in "Attendant was Involved'.
Attendant-handled calls are further discussed in paragraph 5.04.
Direct-in trunks will show the extension number as the called
party (for example, Dial-in trunks). However, the "Digits Dialed'
field is blank If the trunk is directed to a hunt group, the
extension that answered the call is reported.
On incoming calls, an "E" is reported if the trunk hangs up while
listening to reorder tone, or a "B" if the trunk hangs up while
listening to busy tone. A 7" is reported if the incoming call is
answered with TAFAS.
ARS Modified Digits
5.06 If during Programming the programmer enters ~4 before an
Add or Delete Digit, those digits between the ~4 and the next ++
will not be printed in the SMDR records. These digits also will not
appear in the SUPERSET 4 set display as they are being sent out
Examples
5.07 Typical SMDR printouts are shown in Table 5-l.
Page 18