Mitel SX-200 Documentation page 394

SPEED CALL
D e s c r i p t i o n
This feature allows a SUPERSET 4 user to save frequently dialed tele-
phone numbers and to access these numbers by pressing a single
button. The quantity of speed call numbers available to a SUPERSET 4
user is dependent on the number of lines programmed to appear at the
set. Any unused (unassigned) line select buttons can be used to save
speed call numbers.
To check saved numbers, press the DISPLAY button, then the required
line select button. The currently saved speed call number is displayed
on the alphanumeric display. Up to 16 digits can be displayed at once.
If the saved number is greater in length, an arrow (-) is displayed.
Press the - feature button to view the remaining characters.
C o n d i t i o n s
None
O p e r a t i o n
To Set Up or Modify a Speed Call Number:
. .
With the handset on-hook press the PROGRAM feature button.
l
Press the SPEED CALL feature button.
l
Press an unused speed call button.
l
Dial the number to be stored. Insert into the dialing sequence:
l
suspended while other digits are dialed manually; e.g., the gen-
eral number for directory assistance
1212; the area code is to be dialed manually. The ~3 has to be
followed by a 2-digit number signifying the quantity of digits to
be dialed. This number is between 01 and 16. In the directory
assistance example, the number to be stored would be:
where 9 is a trunk access code.
alphanumeric display. If correct, press the SAVE feature button.
The speed call number is now saved.
There are two ways to correct a programming error before the
SAVE feature button is pressed:
1. Use the - feature button to backspace to and clear the
2. To cancel the entire current entry, press the EXrT feature
9x13035551212
incorrect entry.
button.
SECT I ON MITL9105/911
1 + (area code) + 555 +
is
P a g e 3 3