Mitel SX-200 Documentation page 580

3. PROGRAMMING
General
Programming the SX-lOO/SX-200 PABX for the Speed Call fea-
3.01
ture consists of the following steps:
Complete the Installation Forms (in Volume 3) with respect to
Speed Call. Examples showing typical entries are shown at the
back of this practice.
Ensure that the PABX is fitted with Generic 217 Software.
In the Programming Mode, enter the System Options, Speed
Call Feature Access Code and COS Options required for Speed
Call (see Section MITL9105/91
Place the PABX in the Extended Programming Mode, initialize
the extended RAM and choose the proper Configuration (see
(b)). This may only be performed when the system is idle.
Perform the required programming to enable the Speed Call
feature. This procedure is amplified in paragraphs 3.09 - 3.12.
This step is only necessary if personal speed call tables have to
be assigned.
When all programming is completed, the console is returned to
the normal operational state. The defining of speed call num-
bers is done in this state as detailed in Part 4.
Installation Forms
3.02 The following Speed Call Installation- Forms are supplied with
Volume 3:
Form SC-l, Speed Call Table Allocations
Form SC-2, Personal Table Programming Form.
3.03 Form SC-l is used to list a speed call table as a common-use
table or as a personal table. It includes data concerning the
equipment number and COS assignments, and whether the saved
number redial facility is enabled for any of the tables. This information
is tabulated and is then used in conjunction with Form SC-2 to per-
form table programming. The information is also used to provide the
attendant, and a personal table user with basic data (required to define
the speed call numbers). An example of Form SC-l, based on Figure
2-1, is shown at the back of this Practice.
3.04 The personal table information compiled on Form SC-l is en-
tered on Form SC-2. This form is used to program the required
data as detailed in later paragraphs. Upon completion of programming
the speed call entry access number, and whether the saved number
redial is enabled, is entered on the Speed Call Number Record Card-
SECTION MITL9105/911 O-096-220-NA
Page 9