Mitel SX-200 Documentation page 370

Call Forwarding - Don't Answer has no effect if the SUPERSET 4
l
set is operated in the Auto-Answer (handsfree) mode.
If an invalid number is selected as a forwarding number, reorder
tone is returned, and the alphanumeric display indicates this fact.
Call Forwarding does not apply if the calling extension is the
l
party to which the call would be forwarded.
Operation
The current Call Forwarding type and destination can be displayed on
the alphanumeric display by pressing the display and CALL FWD fea-
ture buttons in that order.
To Set Up or Modify Call Forwarding:
With the handset on-hook, press the PROGRAM feature button.
l
Press the CALL FWD feature button.
l
The alphanumeric display shows a Call Forwarding type. If the
l
displayed type is required, press the YES feature button. If the
type is not required, press the NO feature button; another Call
Forwarding type is then displayed.
Dial the Call Forwarding destination (if to another extension or
l
the attendant) or if to an outside number, press the Speed Call
(line select) button associated with that number.
Check your Call Forwarding destination as displayed on the al-
l
phanumeric display. If correct, press the SAVE feature button.
The Call Forwarding type and destination are now stored.
Call Forwarding is now active, and the word FWD is displayed as
l
a reminder.
There are two ways to correct a programming error before the
SAVE feature button is pressed:
1. Use the - feature button to backspace to and clear the
incorrect entry.
2. To cancel the entire current entry, press the EXIT feature
button.
To Cancel Call Forwarding:
Press the SELECT feature button.
l
Dial '1' (feature number 1 is Call Forwarding (1:FWD)).
l
Press the OFF feature button.
l
To Reactivate Call Forwarding:
Press the SELECT feature button.
l
Dial '1' (feature number 1 is Call Forwarding (l:FWD)).
l
Press the ON feature button.
l
SECTION MITL91 OS/91 10-096-l 07-NA
Page 9