Mitel SX-200 Documentation page 42

Page 36
Line Select/Speed Call Buttons
10.02 There are 15 line select/speed call buttons which can be con-
figured (at the time of PABX programming) to select preassign-
ed lines, in order to receive or originate calls. These lines can be a mix
of a variety of line types (e.g., key, multiple call, direct trunk select,
personal outgoing, and private). Those buttons not assigned a line are
available to the user for storage and later use of speed call numbers.
Hold Button
10.03 This button allows the set user to hold any call at the set. The
line on which the call is held is indicated by the adjacent line
status display flashing on and off. When a call is held, the alphanu-
meric display prompts the user to select another line; only after an-
other line is selected will dial tone be returned. Otherwise, the call is
held and can be retrieved by pressing the associated line select but-
ton.
Feature Buttons
10.04 There are six feature buttons. Each button is associated with a
specific group of word prompts on the features display.
10.05 In operation, the set displays only the word prompts that are /
valid at that time. In any specific group of prompts, only one \
prompt can be displayed. The user selects the feature, or PABX action,
by pressing the button immediately below the prompt that describes
that action.
Supplementary Feature
10.06 Display: Allows the user to have displayed on the alphanumeric
display:
Identification of lines at the set
l Saved numbers for speed call
Number saved for redial
Identification of source of incoming calls
l
Identification of caller camping on timed-reminder setting
Call forward destination.
l
10.07 The actual item to be displayed is selected after the display
button is pressed, by either pressing a line select/speed call
button (for line identification, caller identification, or speed call num-
ber), or pressing a feature button under the prompt associated with
the item. To clear the display, the EXIT feature button is pressed.
10.08 Select features. Features which may be activated at arty time,
as opposed to those which may be selected only at fixed times,
are displayed on the features display when the select features button
is pressed.
Buttons