Mitel SX-200 Documentation page 582

EXTENDED PROGRAMMING OVERLAV
(LAMP TEST LED FLASHING)
,
TRUNK ABSORB COpNz TABLE
BASIC DISPLAV ABSORB ABS4Xi6
Figure 3-1 Programming Console Overlay
3.11 While in the Extended Programming Mode, the personal tables
are programmed by using the information which had been pre-
viously recorded on Form SC-2 An example of entries made in Form
SC-2 which shows the programming procedure can be found at the
back of this Practice. In addition, Section MITL9105/911 o-096-21 0-NA
details these procedures, and includes typical display examples.
3.12 When all extended programming is completed, the PABX is
returned to
bers may be entered in the enabled tables as detailed in Part 4.
Speed Call Number Record Cards
3.13 The Speed Call Number Record, Form SC-3, is intended to be a
record of common-use speed call numbers for the user. Initial
basic data isentered
the user for completion. When completed, the user compiles lists of
the speed call numbers together with their Entry Access numbers,
according to the Class of Service and distributes them to the relevant
stations of concern. Form SC-3 is maintained by the user as a master
record which may be subsequently updated when changes occur.
SECTION MITL9105/911
EQPT.
NUMBER NUMBER REDIAL
DELETE
its normal operational state (see Section
on the form by the installer and is then handed to
NEXT
Page 11