Mitel SX-200 Documentation page 46

SECTION MITL9105/9110-096-l OO-NA
Page 40
into view in the alphanumeric display. When the message has
been read, the user must either press the EXIT feature button to
clear the display and leave the message active, or press the
CANCEL feature button to clear the display and cancel the
message. If there are other messages to be read, the user must
press the NEXT feature button to bring the next message into
view.
5: ACC CODE
Account Code. It may be necessary for a user to enter an
account code before being allowed access to a trunk; or a user
may require an SMDR record of an account number against a
call. In either case, the user must press the select features
button and dial '5'. The account number can now be dialed from
the keypad, and the digits are displayed; no DTMF tones are
heard as signaling of the code is a data transfer function. A
correct account code is entered when the user presses the
SAVE feature button. The system' responds with the display
'ACKNOWLEDGED' when the code is recorded on the SMDR, or
'PLEASE TRY LATER' when the SMDR recording device is busy.
More than one code can be associated with a single call.
10.17 The word MIC ON has an advisory function and, when displayed,
it reminds the user that the microphone is on.
40.18 Alphanumeric display area: This is a 16character
for presenting time-of-day, date, digit echoing, speed call num-
ber, call forward destination, last number dialed, timed-reminder set-
ting, call elapsed time and messages from the system.
40.19 Each character is formed from a 5x7 dot matrix.
10.20 Prompt display area: There are 35 word prompts organized
into six groups. Each group relates to one of the six feature
select buttons. The prompts act as a guide to the set user, and
indicate to the user what can be done, and when. To select a function
or feature indicated, the user only has to press the feature select
button beneath the prompt.
10.21 The prompts are organized such that only one word above any
feature button is displayed at any time (except for SWAP CAMP
ON feature). Whenever the feature is not in the Class of Service of a
particular set, or if the choices of actions are less than six, the area
above some feature buttons is left blank. Pressing these buttons has
no effect.
Error Messages
10.22 The data transfer between a SUPERSET 4 set and the system is
monitored continuously. Any problems cause an error message
to be displayed by the alphanumeric display, as follows:
Message: NO COMMUNICATION
display used