Mitel SX-200 Documentation page 409

SECTION MITL91 OS/91 10-096-l 50-NA
SVSTEM POWER
Circuit Card Name
Scanner
Tone Control
Console Control (Dual)
Remote Control - PABX (RCP)
Receiver (Dual or Quad)
Line Circuit (8-station)
Trunk Circuit (4-trunk)
Trunk Circuit (2-trunk)
Notes: 1. The Remote Control PABX card is supplied only when required for use with RMAT
Systems (Section MITL9105/91 lo-098-lOl-NA).
the second console control card.
2. If additional receiver cards are used, they must be placed in the following card posi- (:-
tions on shelf 1 - second receiver position 14, third receiver position 13 and fourth
receiver position 12.
Page 6
MAINTENANCE CONSOLE
Figure 2-4 SX-100 Maintenance Panel
tor. Those cards which should not be removed from the equipment
shelves with the power ON carry a CAUTION notice to that effect.
SX-100 Primary Power Supply
2.12 The system primary power supply (Figure 2-2), is to the right of
the equipment shelf and provides all system power from a 115
power supply faceplate, allow all power to be removed from the sys-
tem.
SX-100 Reserve Power Supply
2.13 The batteries and the charger are housed in a metal enclosure
that forms a pedestal for the SX-100 cabinet weighing approxi-
mately 56.7 kg (125 lb).
TABLE 2-l
CIRCUIT CARD COLOR CODE AND CARD POSITION
Color Code
Red
Orange
Yellow
Green
Green
Blue
Black
B l a c k
Black
MAINTENANCE
Card Position
Shelf 1
Shelf 2
20
19
18
17, 16
16 (see Note 1)
15 (see Note 2)
1 through 14 1 - 12
1 through 14 1 - 12
1 through 14 1 - 12
It occupies the s!ot normally used for
CONNECTOR
x828