Mitel SX-200 Documentation page 319

SECTION MITL91 OS/91 10-096-l OS-NA
TOLL CONTROL
Page 264
Description
Toll Control denies an extension or Dial-In Tie Trunk the ability to
make toll calls. Toll Control may be specified to be active on the first,
or first and second digits dialed. Toll calls are defined as those calls
which have a 0, 1, * or #, as the first or second digit after the mnk
access code has been dialed, or as calls which receive toll supervision.
Denial may be specified to be active on the first and second digits
dialed.
Conditions
To implement toll control it is recommended that Wait for Dial
l
Tone be specified in the Trunk Group Type.
Toll denial must be programmed both on extensions and tnmk
l
groups in order to be effective. This allows toll denial on a trunk
group.
Programming
Program toll control for trunk groups which will be restricted.
l
If Toll Denial is to be implemented on detection of Toll Reversal,
l
the first digit of the Trunk Group Type must be entered as 3.
Program toll control for dial-in tie trunks which will be restricted.
Program toll control for extensions which are to be restricted.
l
If toll control is to be active only on the first digit dialed, sJect
l
System Option 291 (Toll Control - First Digit). If Multi-Digit Toll
Control is required, select System Option 292 (Toll Control -
Multi-Digit). (See Section MITL9105/91
Digit Toll Control.)
Operation
None