Mitel SX-200 Documentation page 514

CONTROL PLAN: If this button is pressed, any one of the 15
l
Control Plans in the Toll Control may be examined or defined. If
the system is in Toll Control Trunk Group Programming, the
Control Plan button may be used to assign a Control Plan to
each COR of the selected Trunk Group.
l TRUNK GROUP: Pressing this button allows the selection of a
specific Trunk Group for programming of specific Toll Control
parameters.
ABSORB UNLOCK: This button allows the Absorb Unlock digits
l
of an Absorb Plan to be defined.
DELETE: Pressing the DELETE button removes the data entered
l
from the active program. If an extension or trunk is to have toll
access, pressing the DELETE button after the TOLL DENY button
removes the extension or trunk from the "toll-denied" list, al-
lowing the equipment to have toll access.
NEXT: Entries in a program may be reviewed by selecting the
l
desired program and pressing the NEXT button. Each time the
NEXT button is pressed, the next entry in the program selected
is displayed.
CANCEL:
l
. .
entry, will remove all new data from temporary storage and
allows the correct information to be entered.
EXTENDED PROGRAMMING OVERlAV
LAMP T O L L
TEST
DENV
TRUNK ABSORB CONTROL TABLE
T O L L R E V G R O U P PlAN
COR BASIC DISPLAV ABSORB ABSORB
NUMBER C O N D E N T R V R E P E A T U N L O C K
Figure 7-l Extended
SECTION MITL91 OS/91 1 O-096-21 2-NA
Pressing the CANCEL button after making a data
(LAMP TEST LED FLASHING)
SPEED
C A L L
ACCESS NUMBER ADD ENTER
PLAN
CONFIRM
Programming Console
CANCEL
.
D E L E T E N E X T
Overlay
1
Page 19