Mitel SX-200 Documentation page 254

NIGHT SERVICE AUTOMATIC SWITCHING
Description
This feature automatically switches the system into Night Service if an
incoming call or recall to the Attendant Console is not answered within
the selected Night Service Time-out period.
Conditions
A new call causing the system to switch to Night Service re-
mains at the Attendant Console.
If the trunk was programmed to a night bell in Night Service,
then it will appear on the bell. If it was programmed to an
extension, it will be rerouted to the extension when the next call
comes in.
A recall will remain on the Attendant Console, but will not appear
on a night bell.
The console must not be active during the Night Service Time-
out period. If the Attendant presses any console button, the
time-out is cancelled.
All calls in progress when Night Service is selected are not
affected.
Depressing the NIGHT key to terminate the night mode also
terminates further Night Service Automatic Switching timing on
an unanswered incoming trunk call.
.
Programming
Select System Option
l
If System Option 164 is selected, the time-out period is 20
l
seconds.
If System Option 165 is selected, the time-out period is 40
l
seconds.
If neither System Option 164 nor 165 is selected, the time-out
l
period is 30 seconds.
Operation
None
SECTION MITL9105/9110-096-I
.
Service Automatic Switching).
163 (Night
05-NA
Page 199