An important point to note in the route selection procedure is
that the various access codes for the trunks available at the
customer's system (i.e., "82","84","92",
when using the ARS feature. A Trunk Group is automatically
selected according to the Area and/or Office code dialed by the
customer.
6.02
The Modify Digits Table can provide up to 12 different sets of
digit-modifying sequences, which are each programmed at the
time of installation. Each set can be associated with a particular route,
and may be used with other routes if the same data is required. The
digit-modifying data enables certain digits to be deleted and/or pro-
grammed digits to be inserted. Referring to Figure 6-3, it will be seen
that a modify digits set (Ml, M2, etc.) of the Modify Digits Table is
allotted to the Route Table. Each modify digits set is programmed to
result in a specific combination of digits which are added to the dial
train and/or cause digits to be deleted from the dial train.
6.03
Referring to the specific examples in paragraph 6.01, and to the
route shown in Table 6-1, it will be found that the digit-
modifying data for the Modify Digits Table in respect to the sequences
Ml through M5, are as shown in Table 6-2.
SECT I ON MITL9105/911
etc.) are not required
Page 11