Mitel SX-200 Documentation page 632

~I\:
;i;.
:.
:::/.
' < \
SECTION MITL9105/911 o-096-31 5-NA
.:;.:
.:.:\
.::,'
6.11 EQPT NUMBER: The number entered after pressing this button
defines the unit at that address as a line or trunk unit. If the
EQPT NUMBER button is pressed and the address of an extension or
trunk unit is entered while the Hunt or Trunk Group program is active,
the equipment number is assigned to the Hunt or Trunk Group being
defined.
6.12 EXTN NUMBER: The l-, 2-, 3- or 4-digit number entered after
pressing EXTN NUMBER button assigns the extension number
to the equipment being programmed.
6.13 FEATURE: Pressing this button selects the Feature program and
allows access codes to be assigned, changed, or removed for
any feature. The FEATURE LED remains lit for as long as the program is
selected.
6.14
EXTN: Pressing this button selects the Extension program and
allows the data defining an extension to be made or changed.
The EXTN LED remains lit while the Extension program is active.
6.15 TRUNK: Pressing the TRUNK button selects the Trunk program
and allows the data describing each trunk to be entered or
changed. The TRUNK LED remains lit while the Trunk program is active.
6.16 HUNT GROUP: Pressing this button allows equipment numbers
forming a Hunt Group to be entered or removed from the
system. The HUNT GROUP LED remains lit for as long as the Hunt
Group program is active.
6.17 TRUNK GROUP: Pressing this button selects the Trunk Group
program and allows new data describing each Trunk Group to
be entered or existing data to be changed. The TRUNK GROUP LED
remains lit for as long as the Trunk Group program is active.
6.18
CANCEL: Pressing the CANCEL button after making a data entry,
will remove all new data from temporary storage,'and allows
the correct information to be entered.
6.19 TYPE: Pressing TYPE button allows the single-digit code iden-
tifying the type of trunk being programmed to be entered, or
the 4-digit Trunk Group code to be entered when programming a
Trunk Group.
6.20 LDN NUMBER: The single-digit entry made by pressing the LDN
NUMBER button while programming a trunk, specifies the LDN
appearance on the Attendant Console at the trunk If the trunk is not to
appear on the Attendant Console, no entry is required.
6.21 DAY NUMBER: Pressing this button allows the day assignment
of a trunk to be entered. The trunk may be assigned to TAFAS
equipment, individual extensions or the attendant or Hunt Group.
Page 31