Mitel SX-200 Documentation page 747

SECTION MITL91 OS/91 1 O-096-SOO-NA
use. tf Y?e pm is idle, dial tone will be heard and LED 3 on
the IPC card prvill light.
2. If any device is connected to the data port, disconnect it
from aO2. PIlug the recorder into J302 and prepare the
recordk?g dewice. Ensure that baud rate switch on the
Scanner Card is set correctly.
3. Enable the recording device for recording.
4. Dial x8& and press the RELEASE key from the console, or
dial 555 + 82 and hang up from the test line.
Note: Dump starts immediately after the code is dialed
from the test line.
5. Obsentt that data is being dumped by observing that LED 4
on the IPC c%d is lit.
6. Upon completion, stop the recorder and disconnect the
recorder from J302.
Note: I# it is necessary to abort the dump, dial x1400 and
press release from the console, or dial 500x800
from the test line and hang up.
7. Reconurect amy device disconnected in Step 2. Enable out-
put to tile deice by dialing *14# and press RELEASE from
consok or 555 + 82 and hang up from test line. If the
output is no% restarted, future data intended for the device
will mre in a buffer until it is full.. Then operational prob-
lems cnay be encountered and a minor alarm will occur. If
date is stored in the buffer, LED 3 will be lit.
Load Customer Data
5.15 This procedure is used for all new installations and to re-
program a system that has lost customer data due to a change
of IPC card or unknown cause. This procedure consists of two major
steps:
(a) Initialize We R/W
(b) Load the data from tape.
If the system has not been powered down for long and IPC
Ram Module has not been changed, Step A may be omitted.
Note: In the case of a new IPC Ram Module, ensure that the RAM
battery switch is on before proceeding. These are normally
shipped v&h the RAM battery switch off (see Section MITL9105/
9 11 o-096200+&A).
c
(a) INITIALIZE THE FWM:
Page 42