Mitel SX-200 Documentation page 669

SECTION MITL9105/911 O-096-450-NA
6. PROGRAMMING AND OPERATION
General
6.01 This Part describes the programming options and the operation
of the utilities required in connection with traffic measure-
ments.
6.02 Traffic Measurement data may be obtained in various modes
and formats as outlined in Part 3. These modes and formats are
dependent on
actual
requirements as outlined below (see Figure 3-l):
(a) Polling Mode. The PABX may be polled by an external Agency
at prescribed intervals, with the data obtained in the form of a
Standard or Extreme Value Mode, and as either a Standard or
Compact Traffic Report.
(b) Autoprint Mode. The PABX may automatically output the traffic
data at regular hourly intervals to an external Agency. Alter-
nately this mode may be employed with the local printer.
(c) The same type of data output may be called up from the PABX
console to a local printer.
Programming
6.03 Telephone Company Traffic personnel and users may select and \"'
perform measurements in the variety of modes and formats
outlined above, with the flexibility of changing these modes and for-
mats to meet changing requirements.
6.04
Programming of the PABX to enable required features and op-
tions is performed at the time of installation. Other features and
options may be subsequently entered, if required, to modify the facili-
ties. The procedures are outlined in the following Sections:
l
Volume 3 Installation Forms
0
Section MITL9105/91 lo-096-210-NA, System Programming.
6.05 Where traffic measurement is a requirement, the relevant op-
tions are entered in the same manner as for the options men-
tioned in the above sections. The type of traffic measurement options
required should be determined from paragraph 6.02 and implemented
as noted in the following paragraphs.
6.06 Table 6-l lists the Traffic Measurement System Options. Option
298 must be enabled for the traffic measurement feature. The
remaining options listed in Table 6-l are then enabled as required, but
note that certain Hotel/Motel printout System Options cannot be en-
abled if System Option 300 (Polling) is selected. The reason -is that
when a local printer is used for printouts, the PABX data port cannot
be used for the polling function. This, and other conflicts are listed in
Table 6-2.
Page 26