Mitel SX-200 Documentation page 673

. .
SECTION MITL9105/91 lo-096-450-NA
Function
Code
*130
*131
~132
*133
TABLE 6-3
TRAFFIC MEASUREMENT FUNCTION CODES
Description
PART A - CONSOLE FUNCTION CODES
Note: See description for System Option 297 in Table 6-l.
Select Start Time. The start time for a Traffic Measurement run may be
displayed and/or set by the console attendant as follows:
l
Enter ~130 from keypad
l
SOURCE display shows: hhmmx (existing time)
where: hh = hours
mm = minutes
x = P if PM
x = (space) if AM or 24-hour clock
l
Enter new start time hhmmy (new time)
where: y = * if PM
y is not required if AM or 24-hour clock
* Press RELEASE key.
.
Select Length of Run. The run length (in multiples of 1 hour) may be dis-
played and/or set by the console attendant as follows:
l
Enter ~131 from keyboard
l
SOURCE display shows: tt (number of hours)
l
Enter new run time tt (1 to 24)
l
Press RELEASE key.
A run length of 24 means that Traffic Measurement will run continuously.
Print Traffic Data. Traffic data may be output by the console attendant as
follows:
l
Enter ~132 from keypad
l
Press RELEASE key.
The current count held in the storage registers are output to printer or tape,
but consult paragraph 4.05.
Cancel Traffic Measurement. The traffic measurement run, if in progress,
may be cancelled by the attendant as follows:
l
Enter ~133 from keypad
l
Press RELEASE button.
This function results in resetting the start time to OO:OO, the run length to 0,
and zeroing the traffic registers. To restart traffic measurement, new start and
run times must be entered.
Page 30