Mitel SX-200 Documentation page 29

Press RELEASE to terminate.
l
To automatically advance, press x after the equipment number. The
next equipment number that is a RAD/RAC/unassigned
If a RAD/RAC is already programmed there, it can be deleted. To delete
a RAD/RAC, dial # when the RAD/RAC is displayed.
To review all defined RADs and RACs:
Dial ~232
l
Continue to dial x to advance to next RAD/RAC
Press RELEASE to terminate.
l
The SOURCE display will show the equipment number in the left corner
and an 0 or 1 in the right corner to indicate a RAD or RAC, respec-
tively.
To record a message on the MITEL
used:
Dial ~240
l
Dial RAC equipment number
l
Dial *
l
Press RELEASE to terminate.
l
. .
When the attendant hears a 50 ms tone, the message may be spoken
into the handset. The recording can be up to 8 seconds in duration.
Press RELEASE to terminate.
To playback a recorded message from a RAC:
Dial ~241
l
Dial RAC equipment number
l
Dial x
l
Press RELEASE to terminate.
l
The message will be heard with the handset; otherwise, busy tone will
be heard if the recording is currently in use.
Press RELEASE to terminate.
The length of the messages on the devices in each Recording Group
must be specified:
Dial ~242
l
Dial Recording Group access code recording duration, in 2-digit
l
seconds (maximum xx)
Press RELEASE to terminate.
l
This duration is used to disconnect the caller from the recording
device and return the caller to Music on Hold. For RAD Recording
Groups, the duration of messages can vary widely. For RAC Recording
SECT I ON MITL9105/91
RAC, the following procedure is
will be shown.
Page 23