Mitel SX-200 Documentation page 160

SECTION MITL91 OS/91
4.
5.
6.
7:
1 .
2.
3.
.
4.
5.
6.
7.
8.
9.
Page 106
10-096-l OS-NA
Connect the recording device to the RS-232 port.
Press the write button on the recording device. Block 1 (and 2)
will be loaded to the IPC. As each block is loaded the LEDs on
the Scanner card will read from 01 to a maximum of 99 for each
block loaded and the third LED on the IPC will remain lit.
When the system has loaded, the LEDs on the Scanner card and
the third LED on the IPC will extinguish. The console clock will
read 0O:OO. Set the time and date accordingly (~5 and ~15).
Disconnect the recording device and reconnect the former de-
vice and enable it as required.
To Load a Specific Data Block:
When loading the system, Data Block 1 (Table 2-6) must be
present or be loaded first.
To load a specific Data Block, set the thumbwheel switches on
the Tone Control card to 3282.
Disconnect the device currently connected to the RS-232 port.
Connect the recording device to the RS-232 port.
From the console dial 555 + 72 + the first Data Block number
(Table 2-6). If other Data blocks are to be loaded, dial x plus the
next Data Block number followed by % for each Data Block Use
a double ++ to signify the last Data Block entry (i.e., 555 + 72 + 2
+ N + 3 + +H, would load data blocks 2 and 3).
Press the autoload button on the IPC and the system will reset;
all calls will be lost and the system will be in automatic transfer
for the duration of the load. The scanner card display will show
AA and all LEDs on the IPC Card will light. During the loading
process, the LEDs of the Scanner will read 01 to RR, where RR
is the final block to be loaded. (Note that RR can not be cal-
culated as it is a reflection of RAM data to be loaded.)
Press the write button on the recording device. Block 'l (and 2)
will be loaded to the IPC. As each block is loaded, the LEDs on
the Scanner card will read from 01 to a maximum of 99 for each
block loaded and the third LED on the IPC will remain lit.
When the system has loaded, the LEDs on the Scanner card and
the third LED on the IPC will extinguish. The console clock will
read 0O:OO. Set the time and date accordingly (~5 and ~15).
Disconnect the recording device and reconnect the former de-
vice and enable it as required.
To load all Data Blocks: