Mitel SX-200 Documentation page 553

Superswitch electronic private automatic branch exchange epabx

Hide thumbs Also See for SX-200:

Table of Contents

SECTION MITL91 OW911

Notes: 1. Digits in DIGITS DELETED column are the NUMBER of digits to be selected.

2. Digits in DIGITS ADDED column are ACTUAL digits to be added.

7. PROGRAMMING

o-096-21 3-NA

MODIFY DlGlTS SEQUENCE EXAMPLE

(See Note 1)

Programming the SX-lOO/SX-200 system for the ARS feature

consists of the following main procedures:

91 lo-096-212-NA)

plications of these should be considered before any program-

ming of the ARS feature (consult paragraph 5.01).

Perform the calculations required to result in the optimum se-

lection of the required routes for the ARS feature.

From the calculations, transcribe the data onto the Installation

Forms relating to the ARS feature. Examples of these forms are

at the end of this Practice.

Ensure that the system is installed with Generic 217 software.

In the Standard Programming mode, enter the required System

Options, COS Option and ARS Feature Access Code (see Sec-

tion MITL9105/91 lo-096-210-NA).

Place the system in the Extended Programming mode. Initialize

the extended RAM, if ARS is to be newly programmed. The

latter can only be done when the system is idle.

Perform the required extended programming to activate the

ARS feature.

When all programming is completed, the console is returned to "

its normal operational state.

features are applicable, the im-

(See Note 2)

Chapters

Table of Contents